Die ursprüngliche Auffindungshilfe beschrieb dies wie folgt:

Beschreibung: Müll, Trümmer und Fusseln auf und zwischen den Elektronikmodulen der Ausrüstung dokumentiert. — Die ursprüngliche Auffindungshilfe beschrieb dies wie folgt: Beschreibung: Müll, Trümmer und Fusseln auf und zwischen den Elektronikmodulen der Ausrüstung dokumentiert.

Similar

HYPERSONIC TEST FACILITY LINER DAMAGE AT NASA PLUM BROOK STATION

CAPE CANAVERAL, Fla. -- The heat shield tiles that will be installed to the backshell of the Orion Multi-Purpose Crew Vehicle's Exploration Flight Test EFT-1 capsule are in a Keith thermal automation oven in the Thermal Protection System Facility at NASA's Kennedy Space Center in Florida. Inside the oven, the tiles will be baked at 2,200 degrees F to cure their ceramic coating. EFT-1 will be used during Orion's first test flight in space. For more information, visit www.nasa.gov/orion. Photo credit: Frankie Martin KSC-2012-1575

S101E5123 - STS-101 - PLT Horowitz at airlock hatch

NINE BLADE FLUTTER CASCADE TUNNELS INTERNAL COMPONENTS BEFORE RE-ASSEMBLY

Ignitron parts, tube #C44. Photograph taken December 14, 1956. Bevatron-1209

KENNEDY SPACE CENTER, FLA. -- At a lab at NASA's Kennedy Space Center, Bob Arp, an aerospace technician with the United Launch Alliance, solders a pin to the socket of the replacement feed-through connector that will be installed in the external fuel tank for space shuttle Atlantis' STS-122 mission. The technician performed this exacting task on the Centaur upper stage for Atlas and Titan launches in 1994 and was specifically chosen for the task. Soldering the connector pins and sockets together addresses the most likely cause of a problem in the engine cutoff sensor system, or ECO system. Some of the tank's ECO sensors failed during propellant tanking for launch attempts on Dec. 6 and Dec. 9. Results of a tanking test on Dec. 18 pointed to an open circuit in the feed-through connector wiring, which is located at the base of the tank. The feed-through connector passes the wires from the inside of the tank to the outside. After the soldering is completed and the connector is reinstalled, shuttle program managers will decide on how to proceed. The launch date for mission STS-122 is under review. Photo credit: NASA/Kim Shiflett KSC-08pd0006

Die ursprüngliche Auffindungshilfe beschrieb dies wie folgt: Beschreibung: Müll, Trümmer und Fusseln auf und zwischen den Elektronikmodulen der Ausrüstung dokumentiert.

description

Zusammenfassung

Betreff: ONBOARD ACTIVITIES, FILTER, SCREENS, DEBRIS, DUST, ONBOARD EQUIPMENT, STS-6 PLUGGING, CHALLENGER (ORBITER), HARDWARE

Aufnahmedatum: 4 / 9 / 1983

Kategorien: Flugstation

Interieur _ Exterieur: Interieur

Ground _ Orbit: Auf der Umlaufbahn

Original: Film - 35MM CN

Preservation File Format: TIFF
STS-6 S06-10-413 - STS-006 - Abfall und Trümmer auf den Filterbildschirmen der Bordausrüstung

date_range

Datum

1983

create

Quelle

The U.S. National Archives

link

Link

https://catalog.archives.gov/

copyright

Copyright-info

No known copyright restrictions